Do cables Matter? Yes. You couldn’t hear your speakers without them! But do expensive cables make your system sound better? Not necessarily
My background is in sound engineering, I have a degree in music recording tech, and I work full time at a pro sound retail store as a repair tech and salesman. I also had this article fact checked by my coworker and fellow repair tech before posting it here.
Cables to matter to the degree that using the right cable for the right application matters. Using the right gauge wire for the amount of power you’re pushing matters, knowing where to use shielded cable vs unshielded cable matters. Knowing where to use balanced vs unbalanced cable matters.
Balanced cable: have 3 terminals. (+) (-) and (ground). A balanced cable from a balanced source carries two out of phase copies of the same signal, and blends them together at the destination. This eliminates hum that is picked up along the length of the cable. Balanced cables include XLR and TRS. Balanced cables are best when running long lengths of cable, because the longer the cable the more EM interference will be picked up along the length of the cable. For short cable runs of a few feet, it won’t make a noticeable difference.
Unbalanced cables have (+) and (-) terminals. Examples of unbalanced cables include most speaker cables, RCA cables, and instrument cables.
Shielded cables have a (+) and (-) terminal where the (-) terminal is a wire shield that is wrapped or woven around the (+) wire. This helps to reduce EM interference. Most small signal carrying cables will be shielded, like RCA cables and instrument cables. Balanced cables are also shielded with the shield connected to ground.
Now, most speaker cables are going to be both unbalanced and unshielded. They have just a positive and negative terminal. Speaker cables need to be heavy gauge wire, this is because speaker cables are typically carrying relatively high amounts of power, so thicker wire=less resistance=more power handling. Speaker cables don’t typically need to be balanced or shielded, this is because the additional EM interference picked up along the length of the cable will be negligible compared to the signal being carried by the cable, and therefore not audible.
So, using the correct gauge of wire is really important for speaker cables because the more power you put though a cable, the more heat you generate as a byproduct. If the cable is too small to handle the load, it will melt the casing, potentially causing a short and damage to your equipment or worst case a fire. So that’s why you don’t use a guitar cable to connect your head to your cab even though they both have 1/4 ends. That’s why you use speaker cable for speakers. That’s it.
What to look for? What actually matters when choosing a cable? There are definitely differences in quality of cables, there are some things that will make a small improvement in fidelity in theory, and higher quality cables will also last longer than cheap cables. There may be a slight difference in noise floor when using a good shielded cable vs cheap shielded cable, and oxygen free copper will have slightly less resistance than standard copper which will improve fidelity. I generally like Mogami/Canere cable because they use good quality wire and good quality casing. Overall, you will pay slightly more for a high quality cable that will last longer and may have a slightly lower noise floor. Anyone selling cables for hundreds of dollars making wild claims about clarity and sound stage is selling you snake oil. Period. Looking at you, audioquest and Cardas. The difference in audio fidelity will likely not be audible in most home audio setups. I wanted to make this post because I see this question pop up here DAILY and I’m getting tired of it. Less beating a dead horse and more focal grande utopia’s please.
I’ll kick it with you. IMO you are spot on, different cables do sound different good or bad. I use to do blind tests with my wife. She would leave the room, I would change out an IC, power or speaker cable and she knew every time something was swapped out or not.
Same. I upgraded IC’s and my partner came home and said why does this sound better? When I said it was the cables, she got mad and said there’s no way. I don’t know…
Unfortunately, there is almost literally no way any of these stories can be true. The math and physics of the interconnects simply does not allow it. Effect of cables is just about barely measurable in a laboratory setting and far below anything humans could actually detect.
In every valid case, it is probably something else going on, including random chance that she thought something is different, or just setting that cables are different or position changed. Humans have no audio memory to speak of, so they can’t really compare anything past a few seconds anyway, so the change must be very large (and easily measurable) to be detectable to human.
Known sources of claims that something sound different involve things like not matching the level within a fraction of dB and not using double-blind testing. Because humans have no way to compare sound accurately to memory, it is easy to make claims that something is better now, and there’s nothing to contradict such claim unless the sound is a clear and obvious downgrade.
It’s not that I refuse to believe stuff like this, it’s that every time someone claims there’s a huge difference, it’s never backed up by anything other than extremely flawed, entirely subjective evidence. I don’t doubt your wife, she may even have the elusive “golden ears” so few of us are blessed with, but if she so easily hears such a massive difference immediately, it should be extremely easy to verify those results scientifically. A test signal should be possible to compare before and after to see if it has improved, or even changed at all. Frequency response graphs should show clear differences in key frequencies. And so on.
Yet this never happens. Actual, reproducible evidence never materializes. Either the person goes silent, or they start attacking blind testing as “flawed methodology” somehow, but never does actual, reliable, scientific data get presented to clearly and irrefutably prove the claim as at least valid, if not objectively true.
This is why, when I hear claims like yours, I instantly dismiss them. I just have no reason to believe it. I’m not calling you a liar, you may both genuinely have experienced what you say, but I have absolutely no reason to take that seriously, more seriously than any claim of anything ever on the internet.
Also, people’s memories are extremely flawed. If you change something, the only way to accurately hear the difference is to A/B it with a switcher. It’s really hard to accurately judge the differences between sounds if you’re leaving even a minute between comparisons. The longer you go, the less accurate your recollection will be.