So I decided to make use of my cheaper sub that only goes down to 40Hz for a stereo sub experience.This is ridiculous hahaha, Can someone just send me £450 so I can buy another PB1000
- REW generated EQs
- User EQ
- Equal loudness contours Volume control
- Crossover for mains and subs
- Delays to time align subs to main
- Extra crossover for the cheap sub to pass through below 40Hz to the good sub
- (5.) delay numbers measured to account for the delay from the extra linear phase crossover on the cheaper sub
Someone moves a speaker by 2cm here and that’s me needing to take a week holiday to re-measure and calculate everything.
The stereo subs make a lot of things better and a very good centre image but overall the quality of the cheap sub even at 80Hz is not on par with the PB1000 and it does stand out. Not sure if I’m gonna keep it yet
Interesting that you are doing all this with JACK! Have you had a look at camillaDSP?
With jack i’ve even ventured down a path of doing some stuff in jack and room correction via Sonarworks / Dirac in a Windows VM running netjack…
it’s been a wild ride.
That’s the spirit. Once my kid is a bit older I’ll go right back into that kind of needles fuckery mode 😅
Oh I’m probably gonna do the kid thing soon. Dive into that. Otherwise I would’ve said I’ll await you over on this side of life
I’m sure you are already aware but just in case
https://torger.se/anders/brutefir.html
https://drc-fir.sourceforge.net
A bit more tedious than Dirac/Sonarwork for sure, but if your are already this deep into it I don’t see that stopping you.